Bi-puller For wiggle wire
Bi-puller for wiggle wire
BIPULR-F.WELDWRE
Register and access more than 75 000 products
The straightening claws generate a pulling motion beginning from their lowest point and terminating at an equal height
In contrast to conventional systems in which the straightening action is applied only at a single point, the pulling action is applied at multiple pulling points equally.
Flat surfaces, edges and curved sheet metal parts can be processed
The claws of the Bi-Puller can be switched from equal lengths to a graduated, curved configuration in seconds.
Caution! The Bi-Puller must not be mounted on hydraulic pulling equipment.
Datasheets(X)
- Use equal-length claws on flat surfaces or edges and graduated claws on curved sheet metal parts
- Manual pulling is sufficient on soft sheet metal parts; on hard and robust sheet metal parts, it is advisable to use the slide hammer
Material | Steel |
Product weight (per item) | 934 g |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!