Welcome to Würth Finland For trade customers only

High-temperature joint grease

High-temperature joint lubricant
JNTGRSE-HINGE-HIGHTEMPERATURE-TUBE-90G

Art.-no. 0892820
EAN 4050641101624
-

Show availability at another Würth Center
Exclusively for trade customers

Register and access more than 75 000 products

Lithium complex-soap, mineral-oil-based lubricating grease with additives to improve corrosion, oxidation and wear protection

Resistant to oxidation - protects against corrosion



Good wear protection



Good load-bearing capacity



Emergency running features


  • Suitable for low sliding velocities

  • Suitable for oscillating applications


Acid-, resin-, silicone- and AOX-free

Notice

Thoroughly clean dirty lubrication points.

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage and processing conditions. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and carry out further development.

Product information

Datasheets(X)

Safety data sheet

Certificates/ Documents / additional info

 | 

 | 

Application area

This high-temperature joint grease is a lithium complex soap grease on the basis of mineral oil with additives to improve corrosion and oxidation protection, wear protection and load bearing capacity.

Chemical basis

Lithium complex

Colour

Black

Smell/fragrance

Characteristic

Density

0.98 g/cm³

Density conditions

at 20°C

Min. temperature conditions

-30 °C

Max. temperature conditions

160 °C

Min. dripping point

220 °C

Water-soluble

No

Silicone-free

Yes

Acid-free

Yes

Resin-free

Yes

AOX-free

Yes

NLGI grade

1-2

Behaviour in the presence of water

1-90

Conditions for behaviour in the presence of water

in accordance with DIN 51807-1

Min. worked penetration

290 x 0.1 mm

Max. worked penetration

310 x 0.1 mm

Worked penetration conditions

in accordance with DIN ISO 2137

Oxidation-resistant

DIN 51808

Weight of content

90 g

Container

Tube

Shelf life from production

36 Month

Suitable glove:
 
Product
Description
Nitrile chemical protective glove With cotton velour finish inside
Nitrile chemical protective glove With cotton velour finish inside
Description:
Permeation level: 6
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
Permeation level
< 10 min
0
≥ 10 min
1
≥ 30 min
2
≥ 60 min
3
≥ 120 min
4
≥ 240 min
5
≥ 480 min
6

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.

Art.-no.
Cust. Mat. No.

Hazardous Material

Product information

Datasheets()

Datasheets ()

CAD data  | 

Certificates/ Documents / additional info

 | 

 | 

Technical information