Plastic adhesion promoter SR
Plastic adhesion promoter SR
PRIM-PLA-PRIMER-SR-400ML
Register and access more than 75 000 products
Even application rate
Even, thin moistening of the spot area
High yield due to constant atomisation pressure
Excellent adhesion properties
Dries quickly
Not suitable for PE, Styrofoam and synthetic resin-coated surfaces. After use, turn the can upside down and spray until the nozzle is empty.
The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
For plastic parts such as PP, PP/EPDM, ABS, SAN, PC, PA, PUR-RIM, R-TPU, PPO, PBT, PUR soft foam, UP-GF plastics.
Lightly roughen the surface to be treated and clean thoroughly with silicone remover. The surface must be clean, dry and free from grease. Shake the can well for approx. 2 minutes before use. Apply one thin (1–2 µm) spray pass at a distance of approx. 20–30 cm. Can be painted after approx. 10 minutes with all commercially available top-coat systems.
Contents | 400 ml |
Chemical basis | Resin |
Colour | Transparent |
Density | 0.75 g/cm³ |
Density conditions | at 20°C |
VOC concentration (CH) | 728 g/l |
Min. coating thickness | 1 µm |
Max. coating thickness | 2 µm |
Min. spraying distance | 20 cm |
Max. spraying distance | 30 cm |
Unleaded | Yes |
Shelf life from production | 36 Month |
Acid-free | Yes |
Chlorine-free | Yes |
Silicone-free | Yes |
Water-soluble | Yes |
Conditions for drying time | at 20°C |
Min. drying time | 15 min |
Max. drying time | 20 min |
Max. proportion of solids | 2.3 % |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!