Welcome to Würth Finland For trade customers only

REPLAST plastic cleaner

REPLAST plastic cleaner
REPSYS-PLA-CLEANER-500ML
REPLAST

Art.-no. 08935001
EAN 4050641134127

-

Show availability at another Würth Center
Exclusively for trade customers

Register and access more than 75 000 products

Effortless and thorough cleaning
  • Good at cleaning

  • Removes grease and oils
Notice

Carry out preliminary tests to ensure surface compatibility.

The usage instructions are recommendations based on the tests we have conducted and on our experience; we advise conducting your own tests before each application. Due to the wide range of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no liability is assumed in relation to the provision of this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting in bad faith. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further enhance products.

Product information

Datasheets(X)

Safety data sheet

Certificates/ Documents / additional info

 | 

 | 

Application area

The plastic cleaner easily loosens and removes soiling, such as silicone residues, insects, oils and grease. Specifically for cleaning tasks in the automotive sector (bumpers and all other plastic parts). Caravans, sports boats, plastic garden furniture, etc. can also be cleaned.

Instructions

Evenly spray the surfaces to be cleaned. Allow the product to work for at least 2 minutes before wiping dry with a clean, lint-free cloth. Always wipe in one direction. A new cloth should be used each time.

Contents

500 ml

pH value

12.1

Suitable glove:
 
Product
Description
Nitrile chemical protective glove With cotton velour finish inside
Nitrile chemical protective glove With cotton velour finish inside
Description:
Permeation level: 5
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
Permeation level
< 10 min
0
≥ 10 min
1
≥ 30 min
2
≥ 60 min
3
≥ 120 min
4
≥ 240 min
5
≥ 480 min
6

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.

Art.-no.
Cust. Mat. No.

Hazardous Material

Product information

Datasheets()

Datasheets ()

CAD data  | 

Certificates/ Documents / additional info

 | 

 | 

Technical information