Welcome to Würth Finland For trade customers only

Vaku hardener (peroxide hardener)

Hardener for filler
HARD-FILR-VAKU-TUBE-40G

Art.-no. 0892600004
EAN 4045989469703
-

Show availability at another Würth Center
Exclusively for trade customers

Register and access more than 75 000 products

Putty hardener for our polyester putty VAKU 20–VAKU 80
Notice

Please refer to the relevant technical data sheets for details of the exact mixing ratios and properties.

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Product information

Datasheets(X)

Safety data sheet

Certificates/ Documents / additional info

 | 

 | 

Application area

Hardener for our polyester fillers VAKU 20 - VAKU 80

Weight of content

40 g

Colour

Red

Smell/fragrance

Characteristic

Max. temperature resistance

80 °C

pH value

Slightly acidic

Density

1.1 g/cm³

Density conditions

at 20°C

Water-soluble

No

Viscosity/consistency

Pasty

Viscosity

10000 mPas

Viscosity conditions

at 20°C

Suitable glove:
 
Product
Description
Nitrile chemical protective glove With cotton velour finish inside
Nitrile chemical protective glove With cotton velour finish inside
Description:
Permeation level: 2
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
Permeation level
< 10 min
0
≥ 10 min
1
≥ 30 min
2
≥ 60 min
3
≥ 120 min
4
≥ 240 min
5
≥ 480 min
6

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.

Art.-no.
Cust. Mat. No.

Hazardous Material

Product information

Datasheets()

Datasheets ()

CAD data  | 

Certificates/ Documents / additional info

 | 

 | 

Technical information